Rear Lift Cylinder
8
7
6
3
2
5
4
15
5
15
10
1
9
12
14
13
11
ROD CLEVIS
14
Figure 63
1. Hose connection
6. Cap screw
11. Cotter pin
2. Hose connection
7. Ram pivot pin
12. Clevis pin
3. Hydraulic fitting
8. Pivot support
13. Lift arm
4. Hydraulic fitting
9.
Lift pivot shaft
14. Flat washer
5. O–ring
10. Lift cylinder
15. O–ring
Removal (Fig. 63)
1. Before removing any parts from the hydraulic man-
ifold, park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
2. Label all connections for reassembly. Disconnect
hose connections (1 and 2) from hydraulic fittings (3 and
4). Allow hoses to drain into a suitable container
.
CAUTION
CAUTION
The rear lift cylinder is located near the
burns, allow the exhaust pipe to cool be-
Operate all hydraulic controls to relieve
system pressure and avoid injury from
pressurized hydraulic oil.
muffler exhaust pipe. To avoid possible
fore working on the rear lift cylinder.
Hydraulic
System
Reelmaster 2300–D/2600–D Page 4 – 71 Hydraulic System
To Next Page
Loading...
