EasyManua.ls Logo

Toro reelmaster 216 User Manual

Toro reelmaster 216
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OPERATOR’S
MANUAL
FORM NO. 3318-231 GB Rev A
MODEL NO. 03410TE—70001 & UP
REELMASTER
®
216
®
© The Toro Company—1996

Other manuals for Toro reelmaster 216

Question and Answer IconNeed help?

Do you have a question about the Toro reelmaster 216 and is the answer not in the manual?

Toro reelmaster 216 Specifications

General IconGeneral
BrandToro
Modelreelmaster 216
CategoryLawn Mower
LanguageEnglish

Summary

Safety

Safety Precautions

Covers stopping, handling attachments, safety devices, and engine speed.

Before Operating

Controls Overview

Operating Instructions

Diesel Engine Start/Stop

Procedure for starting and stopping the engine on diesel models.

Diesel Fuel System Bleeding

Steps to bleed the fuel system on diesel models.

Diesel Cooling System Bleeding

Procedure for bleeding the cooling system on diesel models.

Gasoline Engine Start/Stop

Procedure for starting and stopping the engine on gasoline models.

Interlock Switch Operation Check

Verifying the correct operation of safety interlock switches.

Mowing Operations and Maintenance

Before Mowing Inspection

Steps to take before starting mowing operations.

After Mowing Cleaning and Inspection

Procedures for cleaning and inspecting the machine after use.

Cutting Unit Characteristics and Daily Adjustments

Information on cutting unit adjustment and daily checks.

Lubrication Procedures

Engine Oil and Filter Change

Component Maintenance

Cutting Unit Setup and Adjustment

Set Height of Cut and Level Rear Roller

Procedure for setting cutting height and leveling the rear roller.

Fixed Cutting Units: Height of Cut

Adjusting cutting height for fixed cutting units.

Adjust Bedknife Parallel to Reel

Procedure for adjusting the bedknife parallel to the reel for floating or fixed units.

Verify Height-of-Cut Setting (Floating)

Using a gauge bar to verify the height-of-cut setting for floating units.

Cutting Unit Mounting and Belts

Mount Cutting Units (Floating/Fixed)

Steps for mounting cutting units to the machine.

Install Counterbalance Springs

Related product manuals