Reel Motor Solenoid Coil Replacement
1. Park machine on a level surface, engage parking
brake, lower the cutting units and turn engine OFF.
2. Disconnect solenoid electrical connector.
3. Remove nut from solenoid.
4. Remove cover and solenoid coil.
5. Install new solenoid coil and secure with nut. Apply
“L
ocktite 242" or equivalent to threads on end of stem
tube before installing nut. Tighten nut to a torque of
15 in-lb. Over-tightening may cause the solenoid valve
to malfunction.
1
Figure 35
6. Connect electrical connector.
1. Reel motor solenoid
4WD Solenoid Coil Replacement
1. Park machine on a level surface, engage parking
brake, lower the cutting units and turn engine OFF.
2. Disconnect solenoid electrical connector.
3. Remove coil nut.
4. Remove coil assembly.
5. Install new coil assembly and secure with coil nut.
Apply
“Locktite 242" or equivalent to threads on end of
stem tube before installing nut. Tighten nut to a torque
of 15 in-lb. Over-tightening may damage coil nut or
cause solenoid valve to malfunction.
1
Figure 36
6. Connect electrical connector.
1. 4WD solenoid
Repairs Page 5 - 30 Reelmaster
®
335-D
To Next Page
Loading...
