23. Before getting off of the seat: D. Stop engine and remove key from switch.
E. Do not park on slopes unless wheels are chocked
A. Set parking brake. or b
locked.
B. Move traction pedal to neutral and wait for reels
t
o stop. 24. Use only a rigid tow bar if it becomes necessary to
C. Disengage cutting units and wait for reels to stop. tow mach
ine. Use trailer for normal transport.
While Doing Maintenance, Troubleshooting, Testing, Adjustments or Repairs
25. Before servicing or making any adjustments, stop
engine and remove key from switch.
26. Make sure machine is in safe operating condition by
keeping all nuts, bolts and screws tight.
27. Make sure all hydraulic line connections are tight,
and
all hydraulic hoses and lines are in good condition
before applying pressure to the system.
28. Keep body and hands away from pin hole leaks or
nozzles
that eject high pressure hydraulic fluid. Use
cardboard or paper to find hydraulic leaks. Hydraulic
fluid escaping under pressure can penetrate skin and
cause injury. Fluid accidentally injected into the skin
must be surgically removed within a few hours by a
doctor familiar with this form of injury or gangrene may
result.
29. Before disconnecting or performing any work on the
hyd
raulic system, all pressure in system must be re-
lieved by lowering cutting units to the ground and stop-
ping the engine.
30. If major repairs are ever need or assistance is
d
esired, contact an Authorized Toro Distributor.
31. To reduce potential fire hazard, keep engine area
free of excessive grease, grass, leaves and dirt. Clean
protective screen on back of machine frequently.
32. If engine must be running to perform maintenance
or an adjustment, keep hands, feet, clothing and other
parts of the body away from cutting units and other
moving parts. Keep all bystanders away.
33. Do not overspeed engine by changing governor
se
tting. To assure safety and accuracy, have an Author-
ized Toro Distributor check maximum engine speed.
34. Shut engine off before checking or adding oil to
e
ngine crankcase.
35. Disconnect battery before checking or adding oil to
the crankcase.
36. Toro recommends that two people be used to back-
lap reels. Each person has specific duties and must
communicate with one another. Refer to Cutting Unit
Operator’s Manual for specific backlapping instructions.
37. At the time of manufacture, the machine conformed
t
o the safety standards for riding mowers. To assure
optimum performance and continued safety certification
of the machine, use genuine Toro replacement parts and
accessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with the safety standards, and the warranty may be
voided.
Reelmaster
®
335-D Page 1 - 3 Safety Instructions
To Next Page
Loading...
