Reelmaster 3550--DPage 5 -- 26Electrical System
Fusible Link Harness
The Reelmaster 3550--D uses three (3) fusible links for
circuit protection. These fusible links are located in a
harness that connects the starter B+ terminal to the
main wire harness. If any of these links should fail, cur-
rent to the protected circuit will cease. Refer to electrical
schematic in Chapter 8 -- Foldout Drawings for addition-
al fusible link information.
Testing
Make sure that ignition switch is OFF and disconnect
negative battery cable from battery terminal. Then dis-
connect positive cable from battery (see Battery Service
in the Service and Repairs section of this chapter). Lo-
cate and unplug fusible link connector (P1) from ma-
chinewireharness.Useamultimetertomakesurethat
continuity exists between each terminal pin in connector
P1 and connector J1 at the starter (Fig. 32). If any of the
fusible links are o pen, replace the fusible link harness.
After testing is complete, make sure that fusible link har-
ness connectors are securely attached to starter and
machine wire harness. Connect positive battery cable to
battery terminal first and then connect negative cable to
battery.
Figure 32
FUSIBLE LINK
FUSIBLE LINK
FUSIBLE LINK
To Next Page
Loading...
