Reelmaster 3550--D
DPA Cutting Units
Page 7 -- 4
Special Tools
Special t ools are available from your Toro Distributor.
Some tools may have been supplied with your machine
or are available as TORO parts.
Gauge Bar Assembly
Toro Part Number: 108--6715
Use gauge bar to verify height --of--cut adjustment.
Figure 2
Used for Height--of--
Cut adjustment
Used for groomer
adjustment
Cutting Reel Shim
Toro Part Number: 125--5611
The cutting reel shim (0.002”) is used to ensure that the
bedknife is parallel to the cutting reel.
Figure 3
Cutting Performance Paper
Toro Part Number: 125--5610
Cutting performance paper is used to test the cutting
reel performance a fter adjusting the reel to bedknife
clearance. 300 strips of cutting performance paper are
included in this part number.
Figure 4
To Next Page
Loading...
