Reelmaster 3550−D/3555−D/3575−D Page 5 − 23 Electrical System
Mow/Transport Switch
The switch used for the mow/transport slide is a nor-
mally closed switch. The switch opens when the mow/
transport slide is in the transport position. The switch is
located under the floor plate (Fig 18).
Adjusting
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
2. When the mow/transport lever is on the transport po-
sition, the clearance between the rocker arm and the
switch should be 0.025 to 0.045 in (0.6 to 1.1 mm) at the
closest point (Fig. 19).
3. To adjust switch, loosen fasteners that secure switch
to bracket and position switch to allow correct clearance
between switch and rocker arm. Tighten switch fasten-
ers and recheck switch to rocker arm clearance.
4. After adjusting the switch, use the Diagnostic Dis-
play (see Diagnostic Display − inputs in the Trou-
bleshooting section of this chapter) to verify that the
switch and circuit wiring are functioning correctly.
1. Mow/Transport switch
Figure 18
1
1. Mow/Transport switch 2. Rocker arm
Figure 19
0.025 to 0.045 in
(0.6 to 1.1 mm)
2 1
Electrical
System
To Next Page
Loading...
