10
3352-860
Recycling the Clippings
Your mower comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag on page 11) before
recycling the clippings. If the side discharge chute is
on the mower, remove it and lock the side discharge
door (refer to Removing the Side Discharge Chute on
page 12) before recycling the clippings.
Important: Ensure that
the rear discharge plug
is in place before you
recycle the clippings.
m-8103
Bagging the Clippings
Use the grass bag when you want to collect grass
and leaf clippings from the lawn.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing
the Side Discharge Chute on page 12) before bagging
the clippings.
Warning
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up
the rear door.
2. Remove the rear
discharge plug.
1.
2.
m-8157
3. Route the starter rope around the lower rope
guide.
m-8182
Note: The lower rope guide releases the starter
rope when you pull the recoil start handle.
To Next Page
Loading...
