8
3352-860
Adjusting the Handle
Height
You may raise or lower the handle to a position
comfortable for you.
1. Remove the
lower handle knobs
that attach the
lower handle ends
to the handle
brackets.
A
m-8097
2. Insert the bolt
through the hole in each
of the handle brackets
that sets the handle to
the desired position.
Note: A is the
highest position; B
(either hole) is the
middle position; and
C is the lowest
position.
A
B
C
m-8101
3. Install and tighten
the lower handle knobs
as tight as you can.
A
m-8097
Operation
Starting the Engine
1. Firmly push in
the primer 3 times
with your thumb,
holding the primer
in for a second
before releasing it
each time.
Note: If the air
temperature is
below 55
°
F (13
°
C),
firmly push the
primer in 5 times.
m-8155
2. Hold the blade
control bar (A)
against the handle.
A
m-5578
3. Pull the recoil
starter.
m-5606
4. If the mower does not start in 1 or 2 pulls, press
the primer button 1 or 2 times and try starting it again.
Note: If the mower still does not start, contact an
Authorized Service Dealer.
To Next Page
Loading...
