Toro TIMECUTTER 74685 - Starter Solenoid Replacement

IgnitionSwitchTesting(continued)
g316681
Figure292
•1—StartingCircuitTerminal
•2—(Noconnection)
•3—BatteryTerminal
•4—SeatSwitchandHourMeterT erminal
•5—PTOSwitchT erminal
1.Removethecontrolpanelfromtherightconsole.
2.Disconnecttheharnessfromtheignitionswitch.Gentlyrocktheconnector
backandforthuntilunplugged.
3.Usingadigitalmulti-metersettotheOHMorContinuitysetting,verifythat
continuityexistsbetweentheterminalslistedforeachswitchposition.
4.Usingadigitalmulti-metersettotheOHMorContinuitysetting,verifythat
NOcontinuityexistsbetweentheterminalsnotlistedforeachswitchposition.
Position
Circuit“Make”
1.OFF
None
2.RUN2+3+5+4
3.START
2+3+5+1
StarterSolenoidReplacement
StarterSolenoidRemoval
1.Parkthemachineonalevelsurfaceandsettheparkingbrake.Stopthe
engine,waitforallmovingpartstostopandremovethekey.
2.Fliptheoperator’sseatforward.
3.Disconnectthebatterybyremovingthenegativebatterycablerst,then
thepositivecablefromthebattery.
4.Usingaatheadscrewdriver,prythesolenoidterminalcoverofftorelease
thetabsonthesolenoidcover.
TIMECUTTER®ServiceManual
Page8–19
ElectricalSystem:ServiceandRepairs
3433-938RevA