Toro TIMECUTTER 75740 - Ignition Switch Replacement

PTOSwitchTesting(continued)
g316660
Figure287
4.Usingadigitalmulti-metersettotheOHMorContinuitysetting,verifythe
following:
•Pin2and5shouldhavecontinuity(closed)
•Pin1and4shouldhavecontinuity(closed)
•Pin1and7shouldNOThavecontinuity(open)
•Pin2and8shouldNOThavecontinuity(open)
5.WiththeswitchintheOFFposition(buttonpushedIN):
•Pin1and7shouldhavecontinuity(closed)
•Pin2and8shouldhavecontinuity(closed)
•Pin1and4shouldNOThavecontinuity(open)
•Pin2and5shouldNOThavecontinuity(open)
IgnitionSwitchReplacement
IgnitionSwitchRemoval
1.Parkthemachineonalevelsurfaceandsettheparkingbrake.Stopthe
engine,waitforallmovingpartstostopandremovethekey.
2.Disconnectthebatterybyremovingthenegativebatterycablerst,then
thepositivecablefromthebattery.
3.RemovethePhilipsheadscrewfromthecontrolpanel.
4.Disconnecttheignitionswitch.
ElectricalSystem:ServiceandRepairs
Page8–16
TIMECUTTER®ServiceManual
3433-938RevA