EasyManua.ls Logo

Toro TIMECUTTER 75740 - User Manual

Toro TIMECUTTER 75740
215 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CV
FormNo.3433-938RevA
TIMECUTTER®ServiceManual
Published:June2020
©2020—TheToro®Company
8111LyndaleAvenueSouth
Bloomington,MN55420
OriginalInstructions(EN)
Contactusatwww.Toro.com.
AllRightsReserved

Questions and Answers

  • H
    Holly SpencerAug 16, 2025
    Why Toro TIMECUTTER 75740 Lawn Mower engine does not start?
    • M
      Megan NealAug 16, 2025
      Several factors can cause your Toro Lawn Mower engine to not start, start hard, or fail to keep running. These include an empty fuel tank (fill the fuel tank), incorrect throttle position (ensure the throttle control is in the fast position), a dirty fuel filter (replace the fuel filter), dirt, water, or stale fuel in the fuel system (clean and flush the fuel system), a dirty air cleaner (clean or replace the air cleaner element), or a malfunctioning seat switch (check and replace if faulty). Additionally, check for corroded, loose, or damaged electrical connections (clean and apply dielectric grease), a fouled or improperly gapped spark plug (adjust or replace the spark plug), a disconnected spark plug wire (check the connection), or a worn or damaged switch (test and replace).
  • J
    josephmendozaAug 18, 2025
    Why Toro Lawn Mower engine loses power?
    • S
      scott69Aug 19, 2025
      If your Toro Lawn Mower engine loses power, consider these potential causes: excessive engine load (reduce ground speed or raise the height-of-cut), a dirty air cleaner (clean or replace the air cleaner element), low oil level in the crankcase (add oil), plugged cooling fins and air passages (clean them), a plugged fuel tank vent system (inspect and repair), a dirty fuel filter (replace it), or dirt, water, or stale fuel in the fuel system (clean and flush the system).
  • S
    Sabrina RobertsAug 22, 2025
    How to fix uneven cutting height on Toro Lawn Mower?
    • C
      Christopher MillerAug 22, 2025
      An uneven cutting height with your Toro Lawn Mower may be due to dull blades (sharpen them), bent cutting blades (install new ones), an unlevel mower deck (level it from side-to-side and front-to-rear), a dirty mower underside (clean it), incorrect tire pressure (adjust it), or a bent blade spindle (replace it).
  • X
    xproctorAug 25, 2025
    What to do if Toro TIMECUTTER 75740 blades do not rotate?
    • D
      Deborah DavisAug 26, 2025
      If the blades on your Toro Lawn Mower do not rotate, check for a damaged, worn, loose, or broken mower deck belt (install a new one), a mower deck belt off the pulley (reinstall and check the idler pulley, arm, and spring), or a broken or missing idler spring (replace it).
  • A
    Ashley RamirezAug 27, 2025
    What to do if my Toro TIMECUTTER 75740 does not drive?
    • B
      barbara70Aug 27, 2025
      If your Toro Lawn Mower isn't driving, check if the bypass rods are in the manual move position (place them in the drive position), if the drive belt is worn, loose, off a pulley, or broken (replace it), if the tensioner spring is broken or missing (replace the spring), or if the hydraulic oil level is low in the transaxle (add hydraulic oil).
  • J
    James TaylorAug 31, 2025
    What to do if my Toro TIMECUTTER 75740 Lawn Mower starter does not crank?
    • S
      sduncanAug 31, 2025
      If the starter on your Toro Lawn Mower doesn't crank, it could be due to several reasons: the blade control switch (PTO) is engaged (move it to the disengaged position), the parking brake isn't engaged (move the motion control levers to the neutral lock/park position), the battery is dead (charge the battery), the electrical connections are corroded or loose (check for good contact), a switch is worn or damaged (test and replace), or the fuse is blown (replace the fuse).
  • J
    Joseph PerezSep 3, 2025
    Why Toro TIMECUTTER 75740 vibrates abnormally?
    • J
      Joshua TylerSep 3, 2025
      Abnormal vibration in your Toro Lawn Mower can be caused by several factors: bent or unbalanced cutting blade(s) (install new ones), a loose blade mounting bolt (tighten it), loose engine mounting bolts (tighten them), a loose engine pulley, idler pulley, or blade pulley (tighten the appropriate pulley and check idler springs), a damaged engine pulley (replace it), a bent blade spindle (replace it), or a loose or worn motor mount (check the mounting bolts).
  • C
    Chelsea GriffinSep 5, 2025
    Why Toro TIMECUTTER 75740 Lawn Mower engine overheats?
    • L
      Laura HoltSep 6, 2025
      Your Toro Lawn Mower engine may overheat due to: excessive engine load (reduce ground speed or raise the height-of-cut), a low oil level in the crankcase (add oil), or plugged cooling fins and air passages (remove obstructions and clean).
  • W
    Wendy FarmerSep 9, 2025
    Why Toro TIMECUTTER 75740 pulls to the left or right?
    • L
      Lori AlexanderSep 9, 2025
      If your Toro Lawn Mower pulls to the left or right (with levers fully forward), the tracking may need adjustment, the smart speed shift forks may not be correctly aligned on the motion control linkage (realign and install), or the tire pressure in the drive tires may be incorrect (adjust the tire pressure).
  • J
    jermaine95Sep 12, 2025
    Why Toro TIMECUTTER 75740 clutch does not engage?
    • M
      Margaret WheelerSep 12, 2025
      If the clutch on your Toro Lawn Mower doesn't engage, it could be due to: low voltage supply at the clutch (check coil resistance, battery charge, charging system, and wiring; replace parts if needed), a damaged coil (replace the clutch), inadequate current supply (repair or replace the clutch lead wire or electrical system and clean connector contacts), an excessively large rotor/armature air gap (replace the clutch), or a faulty blade control switch (PTO) (replace the switch).

Summary

Chapter 1 Safety

Safety Instructions

Instructions for safe operation and hazard avoidance.

Think Safety First

Emphasizes crucial safety practices and hazard avoidance.

Safety Symbols

Defines DANGER, WARNING, and CAUTION safety symbols.

Chapter 2 Specifications and Maintenance

Specifications

Detailed technical specifications for the machine models.

Torque Specifications

Recommended torque values for fasteners.

Chapter 3 Troubleshooting

General Troubleshooting

Provides common troubleshooting steps for various issues.

The starter does not crank

Troubleshooting for when the starter motor fails to crank.

Engine loses power

Troubleshooting steps for engine power loss.

Chapter 4 Engine

Chapter 5 Chassis

Chapter 6 Hydrostatic Drive System

Chapter 7 Mower Deck System

Chapter 8 Electrical System

Toro TIMECUTTER 75740 Specifications

General IconGeneral
BrandToro
ModelTIMECUTTER 75740
CategoryLawn Mower
LanguageEnglish

Related product manuals