What to do if my Toro TimeCutter SW 5000 Lawn Mower does not drive?
If your Toro Lawn Mower isn't moving, start by checking if the bypass valves are open. If they are, close the tow valves. If the traction belts are worn, loose, or broken, or if the traction belts are off the pulleys, or if the transmission has failed, contact an Authorized Service Dealer.
How to fix abnormal vibration in Toro Lawn Mower?
To address abnormal vibration in your Toro Lawn Mower, begin by checking if the engine-mounting bolts are loose and tighten them. Also, inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley. Ensure that a blade-mounting bolt is tightened. If the cutting blades are bent or unbalanced, install new cutting blades.
Why is my Toro TimeCutter SW 5000 losing power?
If your Toro Lawn Mower engine is losing power, consider these possible causes. An excessive engine load could be the issue, so try reducing your ground speed. A dirty air cleaner can also cause power loss; clean it. Ensure the oil level in the crankcase is adequate by adding oil if needed. Check for obstructions in the cooling fins and air passages and remove any you find. Replace the spark plug if it is pitted, fouled, or has an incorrect gap. Other potential issues include a blocked fuel-tank vent, a dirty fuel filter, contaminated fuel, or incorrect fuel type. For these issues, it's best to contact an Authorized Service Dealer; otherwise, replace the fuel filter, drain the tank and replace the fuel with the proper type.
Why is my Toro TimeCutter SW 5000 vibrating abnormally?
If your Toro Lawn Mower is experiencing abnormal vibration, begin by tightening the engine mounting bolts. Next, tighten the engine pulley, idler pulley, or blade pulley if any of them are loose. If the engine pulley is damaged or a blade spindle is bent, contact an Authorized Service Dealer. Replace the cutting blade(s) if they are bent or unbalanced. Finally, tighten the blade mounting bolt if it is loose.
How to fix abnormal vibration in my Toro TimeCutter SW 5000?
If your Toro Lawn Mower is vibrating abnormally, here are a few things to check: ensure the engine-mounting bolts are tightened. Also, check if the engine pulley, idler pulley, or blade pulley is loose and tighten the appropriate pulley. Inspect the cutting blade(s); if it/they are bent or unbalanced, install a new cutting blade(s). Make sure the blade-mounting bolt is tightened.
Why is the fuel tank collapsing on my Toro TimeCutter SW 5000 Lawn Mower or the machine frequently running out of fuel?
If your fuel tank is collapsing or the machine frequently runs out of fuel, the air-cleaner paper element might be clogged. Clean the paper element to resolve this issue.
What to do if my Toro TimeCutter SW 5000 Lawn Mower engine does not start?
If your Toro Lawn Mower engine doesn't start, starts with difficulty, or won't stay running, make sure the fuel tank is full. If it's empty, fill it. Also, ensure the choke is turned on. If the air cleaner is dirty, clean or replace it. Check that the spark-plug wire(s) is securely connected. Replace any spark plug(s) that are pitted, fouled, or have an incorrect gap. Replace the fuel filter if it's dirty. Add oil if the oil level in the crankcase is low. If there is incorrect fuel in the fuel tank, drain the tank and replace the fuel with the proper type.
Why is the cutting height uneven on my Toro TimeCutter SW 5000?
If the cutting height of your Toro Lawn Mower is uneven, ensure the blade(s) is sharp and sharpen it if needed. If a cutting blade(s) is bent, install a new one. Level the mower from side-to-side and front-to-rear. Adjust the anti-scalp wheel height if it is not set correctly. Clean the underside of the mower if it is dirty. Adjust the tire pressure to the correct level. If a blade spindle is bent, contact an Authorized Service Dealer.
How to fix Toro Lawn Mower when the starter does not crank?
If the starter on your Toro Lawn Mower does not crank, make sure the blade-control switch is disengaged. If not, move the blade-control switch to Disengaged. Check the battery and charge it if it's dead. Inspect the electrical connections for corrosion or looseness and ensure they have good contact. Also, check the fuse and replace it if it's blown. If a relay or switch is damaged, contact an Authorized Service Dealer.
What to do if my Toro TimeCutter SW 5000 engine won't start?
If your Toro Lawn Mower engine does not start, starts hard, or fails to keep running, start by checking if the fuel tank is empty and fill it if necessary. Ensure the choke is on by moving the choke lever to the On position. Inspect the air cleaner for dirt and clean or replace the element. Verify that the spark plug wire(s) is securely installed on the spark plug. Check the spark plug(s) for pitting, fouling, or incorrect gap and replace if needed. If there is dirt in the fuel filter, replace it. If there is incorrect fuel in the fuel tank, drain the tank and replace the fuel with the proper type. Finally, check the oil level in the crankcase and add oil if it is low. If you suspect dirt, water, or stale fuel is in fuel system, contact an Authorized Service Dealer.
General| Brand | Toro |
|---|---|
| Model | TimeCutter SW 5000 |
| Category | Lawn Mower |
| Language | English |
Engine horsepower rating according to SAE J1940 standards.
Identification of the safety alert symbol for hazard warnings.
Guidelines for safe operation, including training and preparation.
Steps to take before operating the mower for safety.
Key safety precautions during mower operation.
Safety procedures for maintenance, cleaning, and storage.
Safety precautions for transporting the machine.
General safety rules for operating the mower.
Precautions and advice for operating the mower on slopes.
Safety guidelines for towing equipment with the mower.
Sound pressure, sound power, and vibration data.
Sound pressure, sound power, and vibration data.
Chart to determine the degree of slope for safe operation.
Aligning edge with a vertical surface for slope comparison.
Example of comparing slope with a folded edge.
Warning about operating without deflector; stay away from moving parts.
Instructions for servicing, tire pressure, and greasing.
Thrown object and cutting/dismemberment hazard warnings.
Shows height-of-cut settings and reading the operator's manual.
Warning about entanglement hazard with belts; keep guards in place.
Height-of-cut settings for certain models.
Symbols for battery hazards, handling, and warnings.
Symbols for drive controls, oil drain, and system references.
Symbols for Key Choice and Smart Park brake system operation.
Symbol indicating the maximum drawbar pull limit.
General warning to read the operator's manual.
Warning for cutting/pinching hazard of hand, foot, or belt.
Hazard warning against having riders; look behind when backing up.
Indicates throttle settings for engine speed control.
Symbol for the choke control for starting cold engines.
Switch to engage/disengage mower blades and attachments.
Diagrams identifying mower components and control panel layout.
Explanation of ignition, choke, throttle, blade, fuel, and height controls.
How to use the Key Choice switch for mowing in reverse.
Explanation of the warning light for reverse operation.
How the SmartPark switch engages and disengages the parking brake.
Critical warnings about fire and explosion risks with gasoline.
Warnings about health risks from gasoline exposure.
Benefits and instructions for using fuel stabilizer/conditioner.
General safety instructions and decal information for safe operation.
Dangers of mowing on wet grass or steep slopes, and rollovers.
Caution about noise levels and recommendation for hearing protection.
Warning against tampering with safety interlock switches.
Explanation of the system's purpose and design.
Step-by-step procedure to test all safety interlocks.
Procedure and important notes for starting the engine.
How to engage and disengage the mower blades.
How to engage and disengage the SmartPark™ parking brake.
Steps to properly stop the engine.
Description of the mower's driving characteristics.
Warning about the machine's rapid spinning and loss of control.
Procedure for driving the machine forward and backward.
Warning about leaving the mower unattended.
Danger of backing over someone while blades are engaged.
Steps to safely mow in reverse if necessary.
Diagram showing height-of-cut adjustment positions.
How to adjust the seat and steering wheel for comfort and control.
Procedure for adjusting anti-scalp rollers on 42-inch mower decks.
Procedure for adjusting anti-scalp rollers on 50-inch mower decks.
Important safety advice for pushing the machine by hand.
Steps to push the machine by hand, including brake release.
Steps to remove the discharge cover for side discharge.
Diagram for removing the discharge cover.
Steps to install the discharge cover for mulching.
Steps to remove the right baffle for side discharge.
Diagram of baffle stud and knob components.
Warning about severe injury from thrown objects through open holes.
Steps to install the right baffle for mulching.
Diagram for installing the cutoff baffle.
Warning against driving the mower on public streets or roadways.
Steps for transporting the machine on a trailer or truck.
Important advice on using ramps for loading.
Diagram illustrating ramp usage for loading/unloading.
Warnings about tip-over risks and serious injury during loading.
Diagram showing ramp angle and length requirements.
Recommendation to use the fast throttle for mowing.
Advice for cutting grass for the first time.
Guideline for optimal grass cutting amount.
Advice on alternating mowing direction.
Schedule for routine maintenance tasks based on operating hours.
Caution about leaving the key in the ignition switch.
How to raise the seat to access components.
How to loosen the mower-deck curtain for access.
Procedure for safely raising the front of the machine.
Procedure for greasing bearings at specified intervals.
Procedure for servicing the air cleaner elements.
Instructions for cleaning and replacing the foam air filter element.
Instructions for servicing and replacing the paper air filter element.
Procedure for checking engine oil level before each use.
Diagram showing oil fill cap and dipstick area.
Procedure for changing the engine oil.
Schedule for changing the engine oil filter.
Diagram showing how to change the engine oil filter.
Schedule for checking and replacing spark plugs.
Specifications for spark plug type and air gap.
Procedure for removing the spark plug.
Diagram showing how to check the spark plug gap.
Steps to clean the engine's cooling system.
Critical warnings about fire and explosion risks with gasoline.
Procedure for replacing the in-line fuel filter.
Warning about lead and lead compounds in battery components.
Procedure for charging the battery.
Steps to safely remove the battery from the machine.
Steps to safely install the battery into the machine.
Information about fuses and how to replace them.
Procedure for checking and maintaining proper tire pressure.
Procedure to manually release the electric brake.
Guidelines for maintaining sharp and undamaged mower blades.
Warning about risks associated with worn or damaged blades.
Diagram for measuring blade distance from surface (A).
Diagram showing blade rotation for measurement.
Conditions that require blade replacement.
Steps to remove mower blades.
Important note on the correct orientation of the blade's curved part.
Steps for sharpening mower blades.
Steps to install mower blades.
Torque specification for the blade bolt.
Requirements for leveling the mower deck.
Procedure for adjusting the mower deck side-to-side.
Steps to adjust the front-to-rear slope of the mower deck.
Diagram for front-to-rear slope on 2-blade decks.
Steps to remove the mower deck from the machine.
Diagram for removing the front support rod.
Warning about injury risks from uncovered discharge opening.
Procedure for inspecting the grass deflector for damage.
Procedure for inspecting mower belts for wear or cracks.
Procedure for replacing the mower belt.
Diagram showing belt routing for 2-blade mower decks.
Diagram showing belt routing for 3-blade mower decks.
Procedure for cleaning debris from under the front of the mower.
Procedure for washing the underside of the mower deck.
Detailed steps for cleaning and preparing the machine for storage.
Important note on not storing stabilized gasoline over 30 days.
Troubleshooting for fuel tank collapsing or fuel running out.
Troubleshooting for engine overheating problems.
Troubleshooting for when the starter does not crank.
Troubleshooting for when the engine loses power.
Troubleshooting for the machine not driving.
Troubleshooting for abnormal vibration issues.
Wiring diagram for the mower's electrical system.
Legend for wire colors used in the electrical diagram.
List of international distributors with contact details.
Details on data collection, usage, retention, security, and access.
Information relating to Australian Consumer Law.
Information on the GTS starting guarantee for engines.
Details on products covered and warranty periods.
Owner's responsibilities for maintaining the Toro product.
To Next Page