g193261
Figure 30
1. Full 3. Low
2. High
4. T ip the machine onto its side (so that the air
lter is up) to drain the used oil from the oil-ll
tube ( Figure 31 ).
g017281
Figure 31
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-ll tube.
7. W ait 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-ll tube, then
remove the dipstick.
10. Read the oil level on the dipstick ( Figure 30 ).
• If the oil level on the dipstick is too low ,
carefully pour a small amount of oil into the
oil-ll tube, wait 3 minutes, and repeat steps
8 through 10 until the oil level on the dipstick
is correct.
• If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
1 1. Install the dipstick into the oil-ll tube securely .
12. Recycle the used oil properly .
24
To Next Page
Loading...
