8.Settheanti-scalprollerstotopholesorremove
themcompletelyforthisadjustment.
9.Place2blocks(seetablebelow)undertherear
edgeofthecuttingdeckskirt;1oneachsideof
thecuttingdeck(Figure122).
10.Settheheight-of-cutlevertothe3inch(76mm)
position.
11.Place2blocksundereachsideofthefrontedge
ofthedeck,butnotundertheanti-scalproller
bracketsorwelds.
g038090
Figure122
Bottomview
1.Block—7.3cm(2.87
inches)
2.Welds
BlockHeightandRakeTable
DeckSize
BlockHeightRake
Allmower
decks
7.3cm(2.87inches)4.8to6.4mm(3/16to1/4
inch)
12.Carefullyrotatethebladessidetoside(Figure
120).
13.Loosenthelocknuts(Figure123)onall4
cornersandensurethatthemowerdeckis
sittingsecurelyonall4blocks.
14.Removeanyslackfromthedeckhangersand
makesurethedeck-liftfootleverispushedback
againstthestop.
15.Tightenthe4locknuts.
g035851
Figure123
1.Locknuts3.Deckhanger
2.Deck-liftarm4.Chain
16.Ensurethattheblockstsnuglyunderthedeck
skirtandthatallattachmentboltsaretight
17.Continuelevelingthedeckbycheckingthe
front-to-rearbladeslope.
18.Checkthebladesforlevelnessandrepeatdeck
levelingprocedureifnecessary.
79
To Next Page
Loading...
