Getting Started
The wireless rain sensor system is designed for easy installation, setup and years of trouble-free
operation. In most cases, the system components can be installed and fully operational within
minutes. All you will need is a Phillips screwdriver and basic do-it-yourself skills.
If you have problems with any portion of the installation, or the product does not seem to function
properly, refer to the Troubleshooting section on page 22 first. If the problem is not listed, or the
remedy does not seem to help, call the T
oro Irrigation help line at 1-877-345-8676 for assistance.
Here’s all there is to it:
2
The receiver is installed and connected
to your irrigation system controller.
Step 1
The sensor and receiver are tested at close
range to verify operation.
Step 2
RainSensorAlpha7 3/10/2005 3:31 PM Page 2
To Next Page
Loading...
Need help?
General
