Workman 1100/1110/2100/2110 Page 7 – 43 Chassis, Wheels, and Brakes (Rev. B)
Bleed Brake System (Workman 1110 and 2110)
1. Connect a suitable transparent hose to bleeder valve
on wheel cylinder or caliper and submerge other end of
hose in a glass container partially filled with clean brake
fluid.
2. Have a helper pump brake pedal several times, then
hold pedal down firmly.
3. With pedal firmly depressed, open bleeder valve of
brake until pedal fades to floor. Close bleeder valve be-
fore releasing pedal.
4. Repeat procedure until a continuous flow of brake
fluid, with no air bubbles, is released from bleeder valve.
Make sure fluid level is maintained in brake fluid res-
ervoir at all times.
5. Repeat steps 1 to 4 for other brake cylinders and cali-
pers.
CAUTION
After servicing the brakes, always check the
brakes in a wide open, level area that is free of
other persons and obstructions.
6. After bleeding of brakes is completed, road test ve-
hicle to make sure brakes are operating correctly and
pedal is solid.
and Brakes
Chassis, Wheels,
To Next Page
Loading...
