Toro Workman 2110 - Drive System Maintenance; Neutral Adjustment, Tire Inspection, and Suspension

Rev. B
Workman 2100/2110Page 3 – 14Briggs & Stratton Gasoline Engine
Seat Base and Fuel Tank
1. Seat
2. Seat bracket
3. Cap screw
4. Seat base
5. Fuel hose (to filter)
6. Clamp
7. Stand pipe
8. Bushing
9. Gas cap
10. Fuel tank
11. Web strapping (48 inch)
12. Hex head flange screw
13. Flat washer
14. Fuel gauge
15. Grommet
16. Shift bracket
17. Shifter plate
18. Long cap screw (4 used)
19. Knob
20. Short cap screw (4 used)
21. Choke cable
22. Shift cable (2 used)
Figure 16
1
2
3
4
7
8
9
10
11
12
5
6
12
13
14
15
16
22
21
17
18
20
19
Seat Base Removal (Fig. 16)
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Flip both seats forward, and remove them from the
seat base.
3. On Workman 2110 machines, remove parking brake
assembly from seat base (see Parking Brake Disas-
sembly in the Service and Repairs section of Chapter 7
– Chassis, Wheels, and Brakes).
4. Unscrew knob from the shift lever. Remove four
short cap screws securing the shift plate to the shift
bracket (Fig. 17).