Toro Workman HD Series - Page 136

Workman HD SeriesPage 6 − 66Drive Train
7. Install PTO input shaft sub−assembly:
A. Insert shifter block onto pin of shift arm. Apply
moly disulfide grease onto both sides of block before
installing.
B. Put shift collar of PTO input shaft sub−assembly
on the shifter block.
C. Install gear with bushing and thrust washer onto
input shaft after sliding the assembly toward PTO
shaft. Apply moly disulfide grease to bushing of gear
and thrust washer before installing.
D. Slide bearings onto input shaft.
E. Install retaining rings.
1. Retaining ring
2. Retaining ring
3. Input shaft assembly
4. Bearing
5. Bearing
6. Thrust washer
7. Gear
8. Shift arm
9. Shifter block
Figure 136
MOLY
DISULFATE
GREASE
5
4
6
7
3
3. Input shaft assembly
4. Bearing
5. Bearing
6. Thrust washer
7. Gear
Figure 137
3
3. Input shaft assembly
Figure 138
6
7
6. Thrust washer 7. Gear
Figure 139