Workman HDX/HDX−D Page 10 − 21 Front Wheel Drive (4WD)
IMPORTANT: When installing female output hub as-
sembly into gear case, be careful to not damage the
seal in the gear case. The seal cannot be serviced
separately.
6. Press the new female output hub/bearing assembly
into the gear case from the inside. The bearing has a
slight interference fit to the bore, so it should not take
much force to press in. Take care to not damage the seal
during installation of the output hub assembly.
7. Place the gear spacer to the gear case and then
install the ring gear into the gear case.
1. Gear case
2. Gear spacer
3. Female output hub
Figure 26
2
1
3
8. Set the roller cage on a flat surface with the torsion
spring end facing up. Install nine (9) rollers into the slots
on the bottom row of the cage. If needed, use grease or
petroleum jelly to help hold the rollers in place.
1. Torsion spring 2. Lower roller
Figure 27
2
1
Front Wheel
Drive (4WD)
To Next Page
Loading...
