Toro Workman MDX - Page 103

Workman MD/MDX Drive TrainPage 5 -- 41
4. On Workman MD, assemble governor fork.
1. Ball bearing 2. RH case (bearing bore)
Figure 63
1
2
A. Install ball bearing into the bore of the case (RH).
1. Governor shaft 2. Boss
Figure 64
1
2
IMPORTANT: Make sure to not damage the oil seal
when installing the governor shaft into the governor
boss.
B. Lubricate governor shaft with molybdenum disul-
fide grease before installing.
C. Install governor shaft into the boss.
Drive Train