Workman MD/MDX
Drive Train
Page 5 -- 36
1. Governor sleeve 2. Input shaft
Figure 53
1
2
C. On Workman MD, apply molybdenum disulfide
grease to the inside of the governor sleeve. Slide
sleeve onto the input shaft. Make sure to engage
sleeve slot with lock pin.
1. Pivot point 2. Governor plate
Figure 54
1
2
D. On Workman MD, make sure to apply molybde-
num disulfide grease to the pivot points of the
weights on the governor plate unit.
To Next Page
Loading...
