Toro Z Master 74048TE - Adjusting the Height of Cut; Adjusting the Anti-Scalp Rollers

AdjustingtheHeightofCut
ForMachineswithanElectric
DeckLift
1.Pushuponthedeck-liftswitch(Figure30).
g332765
Figure30
1.Pushuptoraisethedeck.2.Pushdowntolowerthe
deck.
2.Selectaholeintheheight-of-cutbracket
correspondingtotheheightofcutdesired,and
insertthepin(Figure31).
g332766
Figure31
1.Height-of-cutpin2.Height-of-cutbracket
3.Pushdownonthedeck-liftswitchtosetthe
heightofcut(Figure30).
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheightofcut,adjustthe
heightoftheanti-scalprollers.
Note:Adjusttheanti-scalprollerssothattherollers
donottouchthegroundinnormal,atmowingareas.
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitchandengagetheparking
brake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Adjusttheanti-scalprollersasshowninFigure
32.
g038079
Figure32
1.Anti-scalproller4.Flangenut
2.Spacer
5.Bolt
3.Bushing
28