Toro Z Master 77248 - Page 69

A.Raisethedecktothetransportposition
(12.7cmor5inches).
B.Slowlyloosentheadjustingscrewonthe
lift-assistspringuntilyoucanremovethe
screw(seeFigure96).
Note:Savethescrewforinstallation.
g035850
Figure96
Reardischargemowerdeckshown
1.Adjustingscrew
3.Setthegapto22to29
mm(7/8to1-1/8inch).
2.Bracket
10.Place2blocks(seeBlockHeightandRake
Table)undertherearedgeofthecuttingdeck
skirt;1oneachsideofthecuttingdeck(Figure
97).
11.Settheheight-of-cutlevertothe3inch(76mm)
position.
12.Place2blocksundereachsideofthefrontedge
ofthedeck,butnotundertheanti-scalproller
bracketsorwelds.
g038090
Figure97
Bottomview
1.Block—7.3cm(2.87
inches)
2.Welds
BlockHeightandRakeTable
Deck
Size
FrontBlockHeightRake
Allmower
decks
7.3cm(2.87inches)4.8to6.4mm(3/16to1/4
inch)
13.Carefullyrotatethebladessidetoside(Figure
94).
14.Loosenthelocknuts(Figure98)onall4corners
andensurethatthemowerdeckissitting
securelyonall4blocks.
15.Removeanyslackfromthedeckhangersand
makesurethedeck-liftfootleverispushedback
againstthestop.
16.Tightenthe4locknuts.
g035851
Figure98
1.Locknuts3.Deckhanger
2.Deckliftarm4.Chain
69