Toro Z Master G3 3000 Series - Burnishing the Brake

HYDRAULIC SYSTEM
5-20 Toro Z Master G3 3000/5000/6000 Series Service Manual
5
Burnishing the Brake
3. Clear the area of any ammable material before
starting the burnishing process.
4. Rotate the drive wheel release valve to the
“operating” position (Fig. 330).
Fig. 328 PICT-8548
2. Remove the two rear wheels (Fig. 329).
Fig. 329 PICT-8550a
5. Engage the parking brake.
6. Install a 1/2” x 6” (approximately) rod or bolt through
the 2” height -of-cut hole (Fig. 331).
Fig. 331 G3CheckValveParkBrake_a
1. Raise the rear of the machine and support it with 2
jack stands placed under the right and left tie down
loops (Fig. 328).
Fig. 330 g. 36 G008957
A. Vertical: “released” B. Horizontal: “operating”
to push the machine to drive the machine
A
B