Toro Z Master G3 3000 Series - Right Park Brake Cable Installation (2012 & Later)

CHASSIS
3-44 Toro Z Master G3 3000/5000/6000 Series Service Manual
3
Right Park Brake Cable Installation (2012 &
Later)
1. Install brake cable with the clevis end out toward the
park brake handle (Fig. 159).
Fig. 159 DSCN-4385a
3. Install the clevis and cotter pin to the right side of the
park brake handle (Fig. 161).
Fig. 161 DSCN-4373a
2. Install the brake cable grooved tting into the slot on
the bottom of the brake pivot assembly and install
the e-ring (Fig. 160).
Fig. 160 DSCN-4375a
4. Install two screws and spacers retaining the park
brake handle assembly to the frame (Fig. 162).
Fig. 162 DSCN-2619a