Toro Z Master G3 3000 Series - Page 59

CHASSIS
3-38 Toro Z Master G3 3000/5000/6000 Series Service Manual
3
5. Route the brake cable through the two clips located
under the frame of the unit and tighten (Fig. 138).
Fig. 138 DSCN-4328a
6. Squeeze the tabs on the conduit tting and install in
the cable bracket located on the frame (Fig. 139).
Fig. 139 DSCN-4327a
7. Slide the brake cable into the cable anchor slot on
the transmission (Fig. 140).
Fig. 140 DSCN-4325a
8. Install the end of the brake cable through the cable
anchor and install an e-ring (Fig. 141).
Fig. 141 DSCN-4361a