Toro Z Master Professional 7500-D Series - Page 68

Holdtheswitchdownuntilbothwingsare
completelyfolded.
2.Positionthemowertothe102mm(4inches)
height-of-cutposition.
3.Unlocktheleftandrightwingdeckcamlocks
(Figure78).
4.Removeandretainthewingdeckheight-of-cut
lynchpin(Figure78).
g239055
Figure78
1.Camlock
3.Lynchpin
2.Clevispin
5.Inserttheheight-of-cutpinintothe102mm(4
inches)locationandinstallthelynchpin.
6.Locktheeachwingdeckcamlock.
7.Starttheengine.
Note:Theparkingbrakemustbeengagedand
themotion-controlleversmustbeouttostart
theengine.Theoperatordoesnothavetobein
theseat.Ensurethatallpersonsareclearof
thedeckwings.
8.Pressandholdthefrontofthedeck-liftswitch
untilthecenterdecklowersandbothwingsare
completelyunfoldedtothecuttingheight.
9.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
10.Measurefromthelevelsurfacetothefronttipof
theleftandrightcenterdeckblades(Figure79).
Themeasurementshouldread102mm(4
inches).
g366987
Figure79
1.108mm(4-1/4inches)
2.Rearbladetip
3.Frontbladetip
4.102mm(4inches)
5.Levelsurface
AdjustingtheCenterDeck
1.Toincreasethecuttingheight,turnthe
adjusterscrewclockwise;todecrease,turnit
counterclockwise.
Loosenthejamnutsonthetopofeachdeck
adjuster.Fine-tunetheadjusteronthefront
deck-liftassemblybyturningittogetthecorrect
heightfortheleftandright,frontbladetipson
thecenterdeck(Figure80).
2.Measurethereartipheight.
Fine-tunetherearadjustersasrequired.You
canadjustthesingle-pointadjustmenttogain
moreadjustment.
68