13
Assembly
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
Description Qty. Use
Rear Wheels 2 Install wheels to traction unit
Retaining rod
Bolt 5/16-18 x 1″ (26 mm)
Locknut 5/16″
1
1
1
Install seat rod
Control lever–right
Control lever–left
Bolt 3/8-1 x 1″ (26 mm)
Spring washer 3/8″
1
1
4
4
Install motion control levers
Key
Operator’s Manual
Engine Operator’s Manual
Parts Catalog
2
1
1
1
Read before operating machine
Registration card 1 Fill out and return to Toro
Install Drive Wheels
1. Uncrate mower.
2. Remove wheel bolts or nuts from rear wheel hubs.
3. Align holes. Mount drive wheels with the valve stem
to the outside of the traction unit.
4. Secure using wheel bolts or nuts provided. Torque to
95 ft-lbs (128 NM).
Tire Pressure
Check the air pressure in the front and rear tires (Fig. 2).
Pressure: 13 psi (90 kPa)
1
m–1872
Figure 2
1. Valve stem
Install Seat Retaining Rod
1. Tilt seat up. Remove 5/16″ (8mm) locknut from bolt
attaching seat retaining rod to seat frame (Fig. 3).
To Next Page
Loading...
