Toro Z-Master Z149 - Positioning the Seat; Pushing the Machine by Hand

22
4. Reinstall the stud nut and washer (Fig. 12).
5. Repeat adjustment on other gage wheels.
m–4167
1
2
3
4
5
Figure 12
1. Gage wheel
2. Stud
3. Washer
4. Nut
5. Wheel nut and washer.
Do not remove.
Center Rollers
1. Disengage the power take off (PTO) and turn the
ignition key to “OFF”. Move controllers to neutral
locked position and apply parking brake.
1. After adjusting height-of-cut, remove bolt and nut
(Fig. 13).
2. Select hole so gage wheel is positioned to the nearest
corresponding height-of-cut desired (Fig. 13).
Note: Do not adjust rollers to support the deck.
3. Reinstall the bolt, center rollers and nut (Fig. 13).
m–4124
1
2
3
Figure 13
1. Center rollers and spacer
2. Nut
3. Bolt
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. To adjust, move the lever sideways to unlock seat
(Fig. 14).
2. Slide the seat to the desired position and release lever
to lock in position.
1
m–3655
Figure 14
1. Adjustment lever
Pushing the Machine by Hand
Important Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.