Toro Z-Master Z149 - Adjusting Hydraulic Pump Neutral

41
1
2
M-4118
Figure 48
1. Right-hand motion control
lever (shown)
2. Neutral lockout position
4. If adjustment is needed, loosen the nut against the
yoke (Fig. 49).
5. Apply slight rearward pressure on the motion control
lever, turn the head of the adjustment bolt in the
appropriate direction until lever is centered in neutral
lock position (keeping rearward pressure on the lever
will keep the pin at the end of the slot and allow the
adjustment bolt to move the lever to the appropriate
position) (Fig. 49).
6. Tighten nut and jam nut.
7. Repeat on opposite side of unit.
1
1
2
6
4 3
2
7
8
m–4118
Figure 49
1. Clevis pin in slot
2. Nut
3. Nut—left-hand thread
4. Bolt
5. Pump rod
6. Double nuts
7. Jam nut
8. Yoke
Adjusting Hydraulic Pump Neutral
Note: Adjust handle neutral first. That has to be correct
before the following adjustment can be made.
Danger
Mechanical or hydraulic jacks may fail to support
machine and cause a serious injury.
• Use jack stand when supporting machine.
• Do not use hydraulic jacks.
1. This adjustment must be made with drive wheels
turning. First raise the frame and block up so drive
wheels can rotate freely.