5
Step
6
Adjusting the Motion
Control Levers
Parts needed for this step:
Qty. Part
1 Control lever–right (assembled)
1 Control lever–left (assembled)
4 Bolt, 3/8 x 1 inch (assembled)
4 Curved washer, 3/8 inch (assembled)
Procedure
1. Check the control
levers for the correct
alignment.
2. If adjustment is
needed, loosen the
4 bolts on the outside of
the levers.
Note: If desired, install
the levers in the top and
middle holes for the high
position or the middle
and bottom holes for the
low position.
m–6866
3. In the neutral position, raise the levers, bringing
them together, and slide them until they are aligned,
then tighten the bolts.
m–6867
m–6868
To Next Page
Loading...
