70
DeutschEnglish
Other messages:
Drive slowly: pops up when battery capacity is < 30%.
Charging: is being displayed under charging.
GPS module integrated into battery pack is searching for satelli-
te signals for speed determination. As long as no GPS signal is
received display in second field will always indicate “remaining range at
currentspeed”(indicationoftime)andaclocksymbolwillbedisplayed.
If remaining run-time is more than 10 hours, remaining running time
will be displayed in whole hours. If it is less, remaining running time is
displayed in hours and minutes. GPS module stops signal searching after
5 minutes if no signal has been received. To activate search again, switch off the system
on“ON/OFF”buttonandthenonagain.
This symbol is displayed when tiller or remote throttle shall be brought into middle
position (stop position). Without doing so, starting will be impossible.
Is displayed in case of overtemperature of motor or batteries (operating with Power
26-104). In this case, motor will dump power independently.
Error:Incaseoferrors,intheundermostbox,“Error”symbolandanerrorcodewillbe
displayed. The code will indicate the component causing the error and the error
itself. Chapter 5.3.4. describes any error codes.
In case of a drop of charge level below 30%, three beeps will be emitted (Cruise T Models
only). Signal beep is repeated in case of drop of charge level below 20% resp. 10%.
Watch the charge status while operating the motor.
To Next Page
Loading...
Need help?
General
