Torqeedo Cruise 2.0 R/T - 4 Starting up; Mounting of Drive to the Boat (Cruise R and Cruise T)

56
DeutschEnglish
4. Starting up
•Ensuresecurefootholdwhenxingtheoutboard.
•Mountoutboardrst(ensureaproperfootholdbefore)andremote
throttle/tiller and battery afterwards.
•Takecarenottocrushhandsorngers.
4.1 Mounting of drive to the boat (Cruise R and Cruise T)
Note: For better clarity in this chapter we will use solely drawings of Cruise R.
Instructions, however, also are relevant for Cruise T – mounting is identical.
• Pleaseensurethatthekickleveratthetransommountisinthe“Lock”
position until the outboard is fitted onto the boat.
• Donotlaythecablearoundsharpedges.
1. Remove the parts supplied with the Cruise from the packaging.
2. Hang the drive on the transom or the motor holder of your boat and tighten the two
mounting clamps.
3. As an alternative the drive can be screwed with four screws (Ø 8 mm / 0.3 inches,
notsupplied)throughtheholesintheclampingmechanismontotheboat’stransom
mount.