Adding and erasing channels manually
After you have automatically programmed all active chmanels into the
"i_V'smemory, you can manually add ,and erase individual channels.
To add or erase a channel in the TV's memory:
1. "l£methe TV m the chmmel you ,_ant m add or erase. If you are
adding a channel, you will need m use the CHANNEL
NUMBERS to select the channel.
2. Press MENU.
3. Press _ or I,,to highlight the SET UP menu.
4. Press i or v to highlight M)D/ERASE.
SET UP
I tl tjr4:1 {ti:,t,.Il=l
_40VE [_ _] 5ELE_ [4 k]
5. Press _ or i,,m highlight M)D or ERASE, whichever function
you w,-mt to perR_rm.
6. Press MENU.
7. Repeat steps 1-6 R_rother channels you w,-mt m add or erase,
or press EXIT to return to normal TV viewing.
RECALL
@
@
®
@
@
MUTE
®
@
@
@
POWER
®
®
i CHANNEL
NUMBERS
MENU
i CHANNEL
i'Ir
i EXIT
Changing channels
To change to the next programmed channel:
Press CHANNEL iv.
To change to a specific channd (programmed or unprogrammed):
Press the CHANNEL NUMBERS (0-9 and 100).
Note: For channels 100 and higher, press the 100 button, and
then the next two channel numbers (fbr example, m select
channel 100, press 100, 0, 0; m select channel 125, press
100,2, 5).
Image tilt correction
When you install or change the direction of the "FV,the picture may
become tilted (caused by the Earth's m_netism). If this happens, use
the image tilt correction feature to obtain the best possible picture.
To adjust the image tilt:
1. Press MENU, and then press 4 or _ until the SET UP menu
appears.
2. Press ,it or V m highlight IMAGE TIYE
3. Press _ or I, to adjust the picture tilt (from-10 to +10).
SET UP
_40VE Iv = ] S_LECT [ 4 _'1
18
To Next Page
Loading...
