17
TELETEXT
Teletext – setting up
Selecting the character set and viewing mode and general information
About teletext
Selecting characters and modes
This TV offers two ways of viewing text – AUTO and LIST which are explained on the next page.
The TEXT button:
Pressing the TEXT button once will bring up the
teletext screen. Pressing it again will
superimpose it over the TV picture. A third press
will return you to the normal TV screen. You need to
return to normal viewing if you wish to change channels.
When you first press the TEXT button to access the text
service, the first page you see will be the initial page.
In Auto mode this displays the main subjects available
and their relevant page numbers.
In List mode you will see whichever page number is
currently stored on the red button.
To access any teletext page, enter the 3 digit page
number, using the numbered buttons on the remote
control, e.g. 430.
To advance to the next page of teletext, press the
P
f
button, to go back to the previous page press the
P
e
button.
2
3
4
5
With the
e
button highlight Mode.
With the
z
and
x
buttons choose Auto or List.
Press EXIT to finish.
From the Set up menu, use the
f
or
e
button to
highlight Character.
Use the
x
button to select your required
character set: Character-1 to Character-6.
Before using teletext you can choose the correct alphabet
(Character) and whether to view in List or Auto mode
(explained on the next page).
1
Teletext continued on the next page…
Set up
Language English
Auto tuning
Manual tuning
Programme sorting
Teletext
Character Character-1
Mode Auto
EXIT : To exit
Use Character-1 for Western European Countries.
To Next Page
Loading...
