120
Troubleshooting
Remote control problems
If you are not receiving a second audio program from a known SAP
source, make sure the MTS feature is set to SAP mode, see
“Selecting stereo/SAP broadcasts” on page 80.
If you hear audio that seems incorrect for the program you are
watching (such as music or a foreign language), the SAP mode may
be on. Set the MTS feature to Stereo mode, see “Selecting
stereo/SAP broadcasts” on page 80.
If you connect a computer using either the PC IN terminal or an
HDMI
®
terminal, make sure that the audio setting is properly set,
see “Connecting a digital audio system” on page 31.
Remote control problems
Remove all obstructions between the remote control and the TV.
Replace the remote control’s batteries, see “Installing batteries” on
page 37.
Your TV’s remote control may not operate certain features on your
external devices. Refer to the User's Guide for your other device to
determine its available features. If your TV remote control does not
operate a specific feature on another device, use the remote control
that came with the device, see “Learning about the remote control”
on page 39.
If the TV still does not act as expected, perform the Reset Factory
Defaults procedure, see “Resetting Factory Defaults” on page 55.
Channel tuning problems
Ensure that the remote control is set to the correct device mode, see
“Learning about the remote control” on page 39.
The Auto Tuning feature may have erased the channel from
memory. Add the channel to the channel memory, see “Storing
channels in memory (optional)” on page 48.
The Lock feature may have blocked the channel. Unblock the
channel, see “Locking channels” on page 91.
If you cannot tune digital channels, check the antenna
configuration. If the problem persists, clear all channels from the
channel list and reprogram channels into memory, see “Storing
channels in memory (optional)” on page 48. For additional
information, see “TV stops responding to controls.” on page 117. If
the problem persists, use the Reset Factory Defaults procedure, see
“Resetting Factory Defaults” on page 55
To Next Page
Loading...
