82
Using the TV’s features
Adjusting the audio
Selecting the optical audio output format
You can select the optical audio output format when you connect a
Dolby
®
Digital decoder or other digital audio systems to the TV’s
Optical Audio Out terminal (see “Connecting a digital audio
system” on page 31).
To select the optical audio output format:
1 Press the MENU button and open the Sound menu.
2 Highlight Audio Setup, and then press the ENTER button.
3 In the Optical Output Format field, select either Dolby
Digital or PCM, depending on your device.
4 To save the new settings, highlight Done, and then press the
ENTER button.
To reset the settings to the factory defaults, highlight Reset,
and then press the ENTER button.
Using the Dolby
®
Digital Dynamic Range Control feature
You can further compress Dolby Digital and Dolby Digital Plus
dynamic range, allowing you to switch from digital to analog
broadcasts at the same dynamic range.
To use the Dolby Digital Dynamic Range Control:
1 Press the MENU button and open the Sound menu.
2 Highlight Audio Setup, and then press the ENTER button.
3 In the Dolby Digital Dynamic Range Control field, select
Compressed. When Standard is selected, the audio outputs
with minimal compression.
4 To save the new settings, highlight Done, and then press the
ENTER button.
To reset the settings to the factory defaults, highlight Reset,
and then press the ENTER button.
❖ This feature is available when the TV is tuned to a digital RF
channel with the Dolby Digital signal.
❖ The Dolby Digital Dynamic Range Control will function in
relation to Optical Output Format (PCM mode).
To Next Page
Loading...
