What does HEAD ERROR mean on my Toshiba Label Maker?
If your Toshiba Label Maker displays 'HEAD ERROR', replace the Print Head and then press the [RESTART] key. This indicates a problem with the Print Head itself.
How to fix a COMMS ERROR on my Toshiba B-852-TS22-QP-R?
If your Toshiba Label Maker shows a 'COMMS ERROR', ensure the interface cable is firmly connected to the computer and that the computer is turned on. This error indicates a communication problem between the label maker and the computer.
What to do if my Toshiba Label Maker shows a RIBBON ERROR?
If your Toshiba Label Maker displays 'RIBBON ERROR', it could be due to: * The ribbon is not fed properly. Remove the ribbon, check its status, and replace it if necessary. If the problem persists, turn off the printer and contact an authorized service representative. * The ribbon has run out. Load a new ribbon and then press the [RESTART] key.
Why is my Toshiba B-852-TS22-QP-R Label Maker printing blank labels?
If your Toshiba Label Maker is not printing anything on the media, it could be due to several reasons: * The media is not loaded properly, load the media correctly. * The ribbon is not loaded properly, ensure the ribbon is correctly installed. * The print head is not installed properly, properly install the print head and close the print head block. * The ribbon and media are not matched, select an appropriate ribbon for the media type being used.
Why is the printed image blurred on my Toshiba B-852-TS22-QP-R?
If the printed image from your Toshiba Label Maker is blurred, it could be because: * The ribbon and media are not matched. Select an appropriate ribbon for the media type being used. * The Print Head is not clean. Clean the print head using the supplied Print Head Cleaner.
Why does the cutter on my Toshiba Label Maker not cut?
If your Toshiba Label Maker's cutter is not working, it might be because: * The Cutter Cover is not attached properly. Attach the Cutter Cover correctly. * The media is jammed in the Cutter. Remove the jammed paper. * The Cutter Blade is dirty. Clean the Cutter Blade.
What does FORMAT ERROR mean on my Toshiba Label Maker?
If your Toshiba Label Maker displays 'FORMAT ERROR', turn the printer off, and then on again. This indicates an error occurred while formatting the flash ROM.
What to do if my Toshiba B-852-TS22-QP-R Label Maker shows POWER FAILURE?
If your Toshiba Label Maker experiences a 'POWER FAILURE', check the power source supplying power to the printer. If the rating is incorrect, or if the printer shares the same power outlet with other high-power consuming appliances, change the outlet. This error indicates a momentary power interruption.
Why is the media not feeding on my Toshiba B-852-TS22-QP-R?
To solve the problem when the media is not fed on your Toshiba Label Maker, ensure the media is loaded properly. Also, check for any errors in the Message Display and resolve them. Change the print condition using the printer driver or a print command to match your printing conditions. Then, clear the error state by pressing the [RESTART] key. The possible causes are improper media loading, or an error condition where the sensor type, printing method, or media pitch are incorrect.
What does CUTTER ERROR mean on my Toshiba B-852-TS22-QP-R Label Maker?
If your Toshiba Label Maker displays 'CUTTER ERROR', it means the media is jammed in the cutter. Remove the jammed media and then press the [RESTART] key. If the problem persists, turn off the printer and contact an authorized service representative.
General| Brand | Toshiba |
|---|---|
| Model | B-852-TS22-QP-R |
| Category | Label Maker |
| Language | English |
To Next Page
