Ŷ
Automatic operation
(auto changeover)
This function is available only for use in
combination with a heat recovery model outdoor
unit. If this function is used with another model of
outdoor unit, “A” (Auto) appears on the remote
controller but the automatic operation is disabled.
6WDUW
6:,1*
)$1
4
3
1
2
67$576723EXWWRQ
3UHVVWKLVEXWWRQWRVWDUWWKHDLUFRQGLWLRQHU
0RGHVHOHFWEXWWRQ02'(
6HOHFW$
7HPSHUDWXUHEXWWRQ
6HWWKHGHVLUHGWHPSHUDWXUH
)DQVSHHGEXWWRQ)$1
6HOHFWRQHRI /2: /2:
0('
0('
+,*+
The OPERATION lamp on the display panel
of the indoor unit lights.
The operating mode is selected in accordance
with the room temperature and operation starts
after approximately 3 minutes.
If the “A” mode is uncomfortable, you can select
the desired conditions manually.
6WRS
67$576723EXWWRQ
3UHVVWKLVEXWWRQDJDLQWRVWRSWKHDLUFRQGLWLRQHU
CAUTION
'LVDJUHHPHQWLQRSHUDWLRQPRGH
If you select AUTOMATIC OPERATION in a model
with no auto-changeover (cooling/heating) control
setting or if you select HEAT in a Cool Only model,
lamp lights up and
and lamps blink
alternately with an alarm sound (pi, pi) from the
air conditioner due to disagreement in operation
mode. Change the operation mode with the MODE
button on the wireless remote controller. This
disagreement indication cannot be deleted by the
wired remote controller.
Ŷ
Timer operation
Use the wired remote controller for timer setting if it
is also in use.
21WLPHUDQG2))WLPHU
6:,1*
)$1
),;
48,(7
+L32:(5
&20)257
6/((3
2
1
3
6HWWLQJ7,0(5
212))7,0(5EXWWRQ RU
3UHVVWKH21RU2))7,0(5EXWWRQVDVUHTXLUHG
The previous timer setting is displayed and flashes
along with ON/OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the
time in ten minute steps.
Pressing the TIMER button continually changes
the time in one hour step.
6(7 EXWWRQ
3UHVVWKH6(7 EXWWRQWRVHWWKHWLPHU
7KHWLPHUWLPHLVLQGLFDWHGDQGWKHWLPHUVWDUWV
&DQFHOOLQJ7,0(5
&/5 EXWWRQ
3UHVVWKH&/5 EXWWRQWRFDQFHOWKHWLPHUVHWWLQJ
CAUTION
When you select the timer operation, the remote
controller automatically transmits the timer signal
to the indoor unit at the specified time. Therefore,
keep the remote controller in a location where it
can transmit the signal to the indoor unit properly.
Otherwise, the time lag of up to 15 minutes will
occur.
If you do not press the SET
button within 30
seconds after setting the time, the setting will be
cancelled.
– 18 –
18-EN
EN
Owner’s Manual
Carrier 1121250221.indb 18Carrier 1121250221.indb 18 9/26/22 11:15 AM9/26/22 11:15 AM