29
Multiple commands
If you want to set up several parameters with one SMS, separate
commands with one of the following:
space
comma “,”
semicolon “;”
For example, the SMS „91+49550111111 92+49550222222 9522 9720”
sets the User1 and User2 numbers, specifies the heat pump model as
“Toshiba Daiseikai 5”, and determines that NO POWER message is sent
immediately in case of a power failure.
When a command in the multi-setup is incorrect, the Owner will receive an
error message. All the correct commands that precede the error command
in the multi-setup command will be activated.
Multi-setup sender will always receive SETUP report SMS from Combi
Control to confirm that all commands arrived to the controller. There can be
spaces before and after a command but not inside a command as this will
interfere with the code.
To Next Page
