Toshiba D-VR16SB - Connections; Using the S-VIDEO OUT or the COMPONENT VIDEO OUT jacks and the AUDIO OUT jacks (Only for DVD); Connecting to external equipment

27EN
Recording Playback EditingIntroduction
Connections
Basic Setup Function Setup OthersVCR Functions
Connecting to external equipment
This unit has three input terminals, AV1, AV2 on the rear
panel and AV3 on the front panel. Be sure that all the
units are off before making connections.
■ Recording from a DVD player, VCR or other
Audio-Video equipment with a Scart output
jack (AV2)
Note
• If the external equipment connected to the AV2 jack
supplies control voltage to this unit via Pin 8 of the Scart
cable, the display functions (e.g. P01) of the remote
control cannot be seen on the TV connected to the AV1.
In this case, turn off the external equipment to prevent
control voltage.
■ Recording from a camcorder or other Audio-
Video equipment with no Scart output jack
(AV3)
Change the setup. (See page 58.)
If no S-Video input jack is available, connect to Video
input jack on the front panel using an RCA Video cable.
DVD/VCR DVD
IN
OUT
Y
P
B
/CB
PR
/CR
L
R
COAXIAL
COMPONENT S-VIDEO
OUT
AUDI O DIGITAL
AUDIO OUT
OUT
VIDEO OUT
ANTENNA
AV2(DECODER)
AV1(TV)
AV output jack
(Scart)
Scart cable (not supplied)
AV2 (DECODER)
If your TV has an S-Video or a Component Video input
jack, use either an S-Video cable (to connect the
S-VIDEO OUT jack) or a Component Video cable (to
connect the COMPONENT VIDEO OUT jacks), and an
Audio Cable (to connect the AUDIO OUT jacks).
- S-Video connection provides the good quality picture.
- Component connection provides the better quality picture.
1) Follow steps 1 and 2 on page 26.
2) Connect S-VIDEO OUT or COMPONENT VIDEO
OUT jacks of this unit to the S-Video or
Component Video input jacks of your TV. Use a
commercially available S-Video cable or
Component video cable.
3) Connect the AUDIO OUT jacks of this unit to
the analogue Audio input jacks of your TV. Use
a commercially available Audio cable.
Note for a TV with no S-Video input jack or Scart socket:
• This unit has no RF modulator, so this type of TV cannot
be used.
• Only component connection is compatible with the
Progressive Scan.
Using the S-VIDEO OUT or the
COMPONENT VIDEO OUT jacks
and the AUDIO OUT jacks (Only
for DVD)
DUBBING VCR/DVD REC
DVD
DVDVCR
LRS-VIDEO VIDEOAV3
AV3(Front)
S-Video cable
(not supplied)
Audio cable
(not supplied)
S-VIDEO
OUT
AUDIO
OUT
DVD/VCR DVD
IN
OUT
Y
P
B
/CB
PR
/CR
L
R
COAXIAL
COMPONENT S-VIDEO
OUT
AUDI O DIGITAL
AUDIO OUT
OUT
VIDEO OUT
ANTENNA
AV2(DECODER)
AV1(TV)
YPB/CB PR/CR
S-Video
cable
(not
supplied)
Audio
cable
(not
supplied)
S-VIDEO INAUDIO IN
Component
Video IN
Component
Video Cable
(not
supplied)
03ConnectionBD.indd2703ConnectionBD.indd27 2006/03/2414:36:232006/03/2414:36:23