Toshiba D-VR16SB - Recording; Checking, cancelling, or correcting the timer programming information

53EN
Recording
Playback EditingIntroduction Connections Basic Setup Function Setup OthersVCR Functions
Checking, cancelling, or
correcting the timer programming
information
In the following example, No. 5 timer programming
overlaps on No. 1 and No. 6 timer programmes. In such
a case, you should correct the programme time to clear
the overlap.
1) Press [T-SET] so that the icon disappears
from the front panel display.
2) Press [TIMER PROG].
Timer Programming list will appear.
3) Check the information on the list to be edited.
4) To clear the timer programming, select the
desired programme using [K / L], then press
[CLEAR].
To correct the timer programming
1) Select the desired programme using [K / L], then
press [ENTER].
2) Correct the timer programming using
[K / L / { / B].
3) Press [ENTER] again.
5) Press [TIMER PROG] to exit.
6) Press [T-SET] to return to the timer-standby
mode.
Note
• If a timer recording is proceeding, that programme is
highlighted in red. In such a case, you cannot select any
other programmes.
Timer Programming
2. ---
3. ---
4. ---
7. ---
8. ---
Overlap
No.1 6
1. 01/01 12:00 13:00 P01 DVD XP ON
5. 01/01 12:30 14:00 P02 DVD SP OFF
6. 01/01 13:45 21:00 P12 DVD SEP OFF
Date Start End CH Mode
DVD
VCR
VCR DVD
PDC
If PDC is “ON”:
• In the timer-standby mode, you can neither turn on the
power nor use the component (VCR or DVD) which is
not currently timer-programmed.
If PDC is “OFF”:
• In the timer-standby mode, you can turn on the power
and use the component (VCR or DVD) which is not
currently timer-programmed.
05RecordingBD.indd5305RecordingBD.indd53 2006/03/2414:37:462006/03/2414:37:46