Toshiba D-VR16SB - Recording; Setting disc protection

Recording
62 EN
Setting disc protection
To prevent accidental over-recording, editing or erasing
of recordings, you can protect them using the Setup
menu.
1
Insert a recordable disc.
In stop mode, press [SETUP].
2
Select “Disc” using [K / L], then press
[ENTER].
Disc menu will appear.
3
Select “Disc Protect OFF ON” using [K / L],
then press [ENTER].
Confirmation window will appear.
4
Select “Yes” using [K / L], then press
[ENTER].
The disc is protected.
Start
Disc
Finalise
Disc Protect OFF ON
Format
No
Yes
Disc Protect OFF ON
Notes
• The Disc Protect setting is available only when a disc recorded in VR mode
is inserted.
• You can select only “Disc Protect ON
OFF” when a protected disc is
inserted.
To cancel the disc protection:
• Select “Disc Protect ON
OFF” at step 3, then select “Yes”.
• If you insert a disc protected with this unit, “Disc Protect ON
OFF” will
appear instead of “OFF ON”.
No
Yes
Disc Protect ON OFF
05RecordingBD.indd6205RecordingBD.indd62 2006/03/2414:37:482006/03/2414:37:48