User’s Manual 4-25
Operating Basics
1. Save data, shut down Windows and turn off the power.
2. Connect the coaxial cable to the TV antenna jack of your computer.
Figure 4-5 Connecting the Coaxial cable
Sound System
This section describes some of the audio control functions.
Adjusting System Volume
You can control the overall level of sound using Windows Volume Mixer.
To launch Volume Mixer, follow the steps below.
1. Right-click the Speakers icon on the Taskbar.
2. Select Open Volume Mixer from the menu.
Adjust speaker volume by moving the slider up or down under Device to
raise or lower the volume of your speakers. Click the Mute button to mute
the volume.
You may see another control under Applications in Volume Mixer. It is the
control for an application which is currently running. The System Sounds
is always displayed since it controls the volume of system sounds.
Changing System Sounds
System sounds are assigned to inform you when certain events happen.
If you have to operate your computer during a thunderstorm and are
connecting the TV tuner to an outside antenna, you should operate your
computer using AC power mode. The AC adaptor offers some protection
against (but does not entirely prevent) possible electric shock caused by
lightning. For complete protection, do not operate your computer during a
thunderstorm.
1. TV tuner jack 2. Coaxial cable
When you have been using a descrambler to receive the programs on
cable TV or satellite broadcasting, connect the set-top box and splitter to
the coaxial cable.
To Next Page
Loading...
