e-STUDIO162/162D/151/151D TEST COMMAND, TROUBLE CODES 10 - 37
66 32 Receive data check
(Executable only when the
FAX is installed.)
[Function]
Use to check the receive data.
[Operation]
33 Signal detection check
(Executable only when the
FAX is installed.)
[Function]
Use to check the signal detection.
[Operation]
34 Communication time
measurement (Executable
only when the FAX is
installed.)
[Function]
Use to measurement the communication time.
[Operation]
37 Speaker sound volume
setting (Executable only
when the FAX is installed.)
[Function]
Use to set the speaker sound volume.
1: NO SOUND
2: LOW
3: MID
4: HIGH
[Operation]
Main
code
Sub
code
Contents Details of function/operation
1) Initial display 2) After completion of reception
"xx" is "OK" or "NG" depending on the check
result.
∗ [CLEAR] key: FAX control is terminated.
RECEIVING RESULT
xx
1) Initial display
When a signal is detected, the display is changed from NONE to the following.
CI/CNG/CED/BT/DT/Flag/SDT/DTMF
∗
[CLEAR] key: FAX control is terminated.
CHECKING NONE
PRESS CLEAR TO STOP
1) Initial display
"xx:xx:xx:xxx" indicates o'clock, minute, second, millisecond.
∗
[CLEAR] key: FAX control is terminated.
COMM. TIME
xx:xx:xx:xxx msec
1) Initial display
2) [
←
/
→
] or after 2sec
Every time when [
→
] key is pressed, the second line is changed in the sequence of 1
→
2
→
3
→
4 → 1.
When [
←
] key is pressed, the sequence is reversed.
∗
[CLEAR] key: FAX control is terminated.
3) [OK (ENTER)] key
xxx: Set content
After 2sec, FAX control is terminated.
SELECT SPEEKER VOL.
PRESS ←, →
SELECT (1-4)
1:NO SOUND
SELECT (1-4)
2:LOW
.....
STORED
xxx
e-STUDIO162_151.book 37 ページ ２００４年１２月２日 木曜日 午後９時３７分
To Next Page
Loading...
