e-STUDIO162/162D/151/151D TEST COMMAND, TROUBLE CODES 10 - 23
46 32 Copier color reproduction
setting (COLOR
REAPPEAR)
[Function]
Used to set color reproduction in each mode. Colors easy to be copied and colors difficult to be copied
can be switched.
∗
This setting has virtually no effect on black-and-white documents.
When this test command is executed, warm-up and shading are performed and the current set value
is displayed. (Default: 0)
Press [START] key to make a copy under the set conditions . At that time, color components are
changed for used in copying.
To change the mode, press [
←
/
→
] key. The code number of the selected mode is dip0slayed on the
LCD.
[Operation]
The operation is similar to test command 46-01.
39 FAX mode sharpness
adjustment (Executable only
when the FAX is installed.)
[Function]
When [START] key is pressed, scan is started with the entered sharpness adjustment value, and the
data of the selected mode stored on the FAX side is changed to the entered value.
[Operation]
Main
code
Sub
code
Contents Details of function/operation
Set value Colors easy to be copied Colors difficult to be copied
0 Purple, Blue, Red Yellow, Green, Water blue
1 Water blue, Green, Blue Purple, Red, Yellow
2 Yellow, Red, Green Blue, Water blue, Purple
Specification component Setting No Remark
Green 0 Default
Red 1
Blue 2
Mode Display item Default setting LED
AE mode (including TS) AE 0 COPY mode lamp
TEXT mode (including TS) TEXT 0 PRINT mode lamp
PHOTO mode PHOTO 0 SCAN mode lamp
Sharpness adjustment value data table
When initializing each data: 1
Mode Sharpness adjustment value
1: STD
2: FINE
3: S-FINE
4: FINE/PHOTO
5: S-FINE/PHOTO
1) Initial display
2) [
←/→] or after 2sec
Every time when [
→] key is pressed, the
second line is changed in the sequence of
No. 1
→ 2 → 3 → 4 → 5 → 1.
When [
←] key is pressed, the sequence is
reversed.
3) Select the arrow key 1-5, and the LED of
[START] key is lighted.
("ZZZZ" is the mode selected among STD,
FINE, S-FINE, FINE/PHOTO, and S-FINE/
PHOTO.)
("X" is the corresponding sharpness adjustment
value of the selected mode stored on the FAX
side.)
∗
[CLEAR] key: Returns to “2)” display.
4) Enter a one-digit value (0-2) as the sharp-
ness adjustment value with [10KEY].
("Y" is the entered sharpness adjustment value.)
∗
[CLEAR] key: Returns to “2)” display.
5) Scan start (self print)
6) Print start (self print)
After completion of printing, returns to “4)”
display.
SHARPNESS SETTING
PRESS
←,→
SHARPNESS SET (1-5)
1:STD
SHARPNESS SETTING
ZZZZ(0-2) X
SHARPNESS SETTING
ZZZZ(0-2) Y
SHARPNESS SETTING
SCAN Y
SHARPNESS SETTING
PRINT Y
e-STUDIO162_151.book 23 ページ ２００４年１２月２日 木曜日 午後９時３７分
To Next Page
Loading...
