9
1
CONNECTING THE POWER CORD
1
Ensure that the power switch of
the unit is in the OFF position.
Insert the attached power cord
into the power cord socket at the
rear of the unit.
2
Plug the other end of the power cord into the nearest outlet.
POWER ON
Turn the power switch on the left side of the unit to the "ON" position. The start ( )
indicator will light up and other indicators which show the initial settings of the
operation panel will also light up to indicate the ready condition. For the initial
settings, see "Initial settings of operation panel" (p.10).
If you use the unit in a country other than the country where the unit was
purchased, you will need to make sure that your local power supply is
compatible with your model. If you plug the unit into an incompatible
power supply, irreparable damage to the unit will result.
• Only insert the power cord into a properly grounded wall socket.
• Do not use extension cords or power strips.
• The unit will enter a power save mode once the set time has elapsed
without any unit operation. The settings of the power save modes can
be modified. See "USER PROGRAMS" (p.46).
• The unit will return to the initial settings a preset amount of time after
the end of a job. The preset amount of time (auto clear time) can be
changed. See "USER PROGRAMS" (p.46).
To Next Page
Loading...
