Chapter 1 PREPARATIONS
14
Saving energy when not in use – energy saving modes –
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Energy saving
modes
Procedure to switch
modes
Conditions to enter into
the mode
Status of equipment
Conditions to recover
from the mode
Automatic
Energy Save
mode
When a specied period of
time
*1
has passed since the
last use of the equipment.
—
“Saving energy - press
START button.” appears on
the touch panel.
• When a button on the
control panel
*2
is pressed.
• When print data or fax
data are received.
Sleep mode
• When the [ENERGY
SAVER] button
*3
is
pressed.
• When a specied period
of time
*4
has passed since
the last use of the
equipment.
• When a particular option
*5
is installed.
• When a particular
protocol
*6
is enabled.
The touch panel display
goes o and the [ENERGY
SAVER] button lights in
green.
Same as the Automatic
Energy Save mode.
Super Sleep
mode
• When the [ENERGY
SAVER] button
*3
is
pressed.
• When a specied period
of time
*4
has passed since
the last use of the
equipment.
When a particular option
*5
is not installed and also
when a particular protocol
*6
is disabled.
Only the MAIN POWER
lamp (green) lights.
• When the [POWER]
button is pressed.
• When fax or print data
*7
through a wired LAN or a
USB cable are received.
• When the time set in
Scheduled Print has
come.
*1 The default value set at the factory shipment is 1 minute.
*2 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*3 [ENERGY SAVER] button on the control panel.
*4 The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 10 minutes).
*5 Any of the Wireless LAN Module and e-BRIDGE ID Gate.
*6 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled, the equipment enters into the Sleep mode. For details, refer to the
following guide:
& TopAccess Guide (PDF): “Chapter 8: [Administration] Tab Page” - “[Setup] Item list”
*7 When a paper exit option such as the Finisher is not installed, the equipment will return to the super sleep mode immediately after print data are
output.
For changing the set period of time for entering into each mode, refer to the following guide:
& MFP Management Guide (PDF): “Chapter 2: SETTING ITEMS (ADMIN)” - “GENERAL”
When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or
the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.
For the European version
Contact your service representative to change the default settings noted above.
If an original is placed on the original glass during the energy saving mode, its size will not be detected even when the equipment
is recovered from this mode. After pressing the [START] or [POWER] button to recover from the mode, such as when “READY” is
displayed on the basic copying function menu, place it on the glass again.
To Next Page
Loading...
Need help?
General
