Toshiba e-STUDIO 207L - Outside Erase

4 EDITING FUNCTIONS
124 Outside Erase
Outside Erase
You can whiten a shadow-like dark part which has appeared outside of the copied image; this has been
caused by a gap between the original glass and the platen sheet. This function is called “outside erase”. It is
useful when you place thick originals such as booklets on the original glass.
 This function is disabled when you place originals on the RADF (optional) or you place them on the
original glass with the RADF or the Original Cover (optional) closed fully.
 When this function is enabled, the automatic density adjustment is disabled. Adjust the density level
manually.
 Originals with an intricate outer shape (e.g. an original with cut-out parts on its edge) may not be copied
properly because this function may not detect the border between the original and areas not belonging
to the original.
1
Place paper in the drawer(s).
When using bypass copying, be sure to set the paper size.
2
Select the drawer for the desired paper size.
3
Press [OUTSIDE ERASE] on the EDIT menu.
4
Set “outside erase”.
1) Press [ON].
2) Adjust the width of the border around the original by pressing either or as required.
When you adjust it to the side, the area to be detected as not belonging to the original is
widened.
When you adjust it to the side, the area to be detected as not belonging to the original is
narrowed.
No settingOutside erase set